KG Chart Printing Issue

[Virus001]

When printing, I have an issue with the marks in the print/preview section.
How do I get the marks to not be "half there" without making the mesh size 10+?
When I make the mesh size that high it makes the project over 140 pages.
At 140 pages, the marks show up whole.
I recently printed out a pattern from this site and half of the N's didn't have one side on them, making the N and a large ^ look exactly the same.
Any suggestions?

[Lord Libidan]

That's a problem I've never heard of before...
Is it just the marks, or are the lines half printing too?

[Virus001]

The lines print just fine. Even when i view it in the print/preview it shows half the symbols unless I expand the mesh size by a great deal. I recently printed out a pattern for my GF, and it showed only half of the symbols of a good portion of the triangles, N's and Z's. i also just tried using bullzip to make it into a pdf file... and the same problem happened. unless the mesh is increased by a factor of 4-5 the symbols only half show up. It's getting annoying.

[LilliumRyn]

when i print out KG stuff, i tend to put a good portion of it into paint and print from there. might not be the most effective way, but it works for me, lol

[Lord Libidan]

Firstly, use cutePDF to make it a pdf, then print it. Bullzip isn't the greatest.
If that doesn't solve your problem, uninstall it, and download the newest version again. It sounds like a bug to me.

If it still doesn't work, then I think you might have to contact the programer. It's not a normal thing...