Master Sword

[blackberrybear]

I'm looking for a simple pattern of the Ocarina of Time Master Sword that is about 2-3 inches high.
Can anyone help? I'm not having much luck. Please and thank you

[Kamfer]

It would be easier if you have a link to a picture. And by a simple pattern, do you mean few colors? And 2-3 inches high on what aida count? 14 count will be different than 20 count.

[blackberrybear]

Shouldn't post questions you're in a hurry, you end up leaving out details (bad me )
I need it to be on 14 count and yes to few colors. Here's a link: http://spriters-resource.com/custom_edi ... heet/17382

[Kamfer]

So, yeah, I gave it a go. And I got a pattern. But most of the details are gone. This pattern is 40 stitches from tip of blade to end, which should be about 3 inches if my math is not off. There's 7 colors, including 1 yellow and 4 light blue for the handle. And if the colors look a bit off in the chart, that's because I've chanced the colors according to what looks good on my thread chart from DMC, not what KG Chart says. In my experience, KG Chart can be a bit off sometimes. So take a look, see what you think.

Sword.sth

(2.66 KiB) Downloaded 197 times

[katdun]

I made this one for a swap a couple years back (please ignore my sad attempt at sewing skills, lol):

Spoiler

No idea if it's the right sword or not, but I think I still have the pattern if you'd like it.

[blackberrybear]

@kamfer I like the pattern, you did good with it thank you
@katdun I don't think its the right sword but if you post the pattern I can use for a different project

[katdun]

Sorry it took so long to post! I couldn't find the pattern, so I re-did it. I know I changed the colors, but I don't remember which ones they were. Here's the pattern and the original so you can compare!

master_sword.png (7.13 KiB) Viewed 4078 times

Master Sword.sth

(4.04 KiB) Downloaded 198 times

Master Sword.pdf

(28.54 KiB) Downloaded 257 times

[blackberrybear]

Cool, Thanks.