Sprite Stitch Board!

I've been thinking to test using perler beads as "graffiti".
What sort of glue should one use to get the plastic beads to stick to concrete? Any ideas?

Found this on the forum...
viewtopic.php?f=9&t=375
THAT'S what I wanna do.

What kind of glue was used? Does one have to clean the surface? etc

He says in his post:

All hung up with superglue, I hope it'll stick around for a while

Maybe you should try to pm him....

Yeah, but I saw he was indoors, maybe I need some tougher stuff than just regular superglue. I don't know. It must withstand cold and moist and so on.
I was going to PM him but I saw he hasn't been here since april, or what it was. But wait. One gets an e-mail notification when receiving a PM, right? Ok, I'll PM him.

I put up a perler bead-Luigi today. But I don't think it will stay up for too long
Gonna buy some glue used for construction purposes in concrete, not just ordinary superglue.
But even with the baddest glue, if not keeping pressure on the beads when the glue hardens, it wont stay up anyway.

luigi is still there

Coolt!

Du borde använda något tvåkomponentslim, s.k. epoxy. Det härdar genom att smälta plast så det sitter riktigt hårt. Måste förvisso appliceras några minuter.

tack för tipset!
but already bought PL400
http://www.tremco-illbruck.co.uk/produc ... index.html
think that'll do

a reminder...
Only glue perler beads where you are allowed to do so.
I'm not encourage anyone in doing any illegal activities.

these are examples on how one probably not should do

/gilla