Sprite Stitch Board!

Posted: **Mon Jun 01, 2009 5:21 pm**

check out this plastic carving I made in tech ed class

Posted: **Tue Jun 02, 2009 4:38 am**

That's a nice carving in plastic.

Posted: **Tue Jun 02, 2009 6:31 am**

very nice, what did you use to carve that?

Posted: **Tue Jun 02, 2009 8:34 am**

Dang, that is really cool. Same question as above^

Posted: **Tue Jun 02, 2009 11:52 am**

i used a dilling machine called a CNC router that was being used in my tech ed class

Posted: **Tue Jun 02, 2009 1:01 pm**

Are you in the class or teaching it?? Either way you deserve an A****

Posted: **Wed Jun 03, 2009 12:29 am**

is that router machine really big and expensive looking or could i afford something like that?

Posted: **Wed Jun 03, 2009 11:09 am**

The router is very large and expensive(unless you have a few thousand $ lying around for the machine, software, and plastic pieces)

Posted: **Wed Jun 03, 2009 11:38 am**

well i did just spend over $4000 on comic books this past month

Posted: **Wed Jun 03, 2009 11:51 am**

even so, I wouldn't know where to get one

triforce plastic carving